P0031 2013 Nissan Rogue Code - Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low
Quick Answer
Air-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. Common causes include Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0031 2013 Nissan Rogue indicates Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low.
- Common causes
- Common causes include Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0031 2013 Nissan Rogue Description
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
What are the Possible Causes of the DTC P0031 2013 Nissan Rogue?
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0031 2013 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0031 2013 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0031 2013 Nissan Rogue code?
Need more information on how to fix the P0031 2013 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0031 2013 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0031 2013 Nissan Rogue Code
1. What are the common symptoms of OBDII code P0031 in a 2013 Nissan Rogue?
The common symptoms of OBDII code P0031 in a 2013 Nissan Rogue include poor fuel economy, rough idling, and potential stalling of the engine.
2. What does the OBDII code P0031 on a 2013 Nissan Rogue indicate?
OBDII code P0031 in a 2013 Nissan Rogue indicates an issue with the Air Fuel Ratio Sensor 1 Heater Bank 1 control circuit being detected as low.
3. What are the possible causes of the Air Fuel Ratio Sensor 1 Heater Bank 1 control circuit being low in a 2013 Nissan Rogue?
Possible causes of this issue in a 2013 Nissan Rogue include a faulty air fuel ratio sensor, damaged wiring or connectors, or a blown fuse related to the sensor.
4. How can I diagnose the OBDII code P0031 in my 2013 Nissan Rogue?
To diagnose OBDII code P0031 in a 2013 Nissan Rogue, you can use an OBDII scanner to retrieve the specific fault code and then inspect the air fuel ratio sensor, wiring, and related components for any visible damage.
5. Can I continue driving my 2013 Nissan Rogue with OBDII code P0031?
While the car may still be operable with OBDII code P0031, it is not advisable to continue driving it for an extended period as it can lead to decreased fuel efficiency and potential engine performance issues.
6. How can I repair the Air Fuel Ratio Sensor 1 Heater Bank 1 control circuit low issue in my 2013 Nissan Rogue?
Repairing the issue involves replacing the faulty air fuel ratio sensor, repairing any damaged wiring or connectors, and ensuring that the fuse related to the sensor is in good condition.
7. Is it possible to reset the OBDII code P0031 in a 2013 Nissan Rogue without fixing the underlying issue?
While you can reset the code using an OBDII scanner, it is important to address the root cause of the problem to prevent the code from reappearing.
8. Will driving with OBDII code P0031 damage my 2013 Nissan Rogue's engine?
Continued driving with OBDII code P0031 may not immediately damage the engine, but it can lead to poor engine performance and decreased fuel efficiency over time if left unresolved.
9. How much does it typically cost to repair OBDII code P0031 in a 2013 Nissan Rogue?
The cost of repairing OBDII code P0031 in a 2013 Nissan Rogue can vary depending on the extent of the issue, but it typically ranges from $200 to $500 for parts and labor.
10. Can a DIY enthusiast fix OBDII code P0031 in a 2013 Nissan Rogue?
While it is possible for a skilled DIY enthusiast to address OBDII code P0031 in a 2013 Nissan Rogue, it is recommended to have the necessary tools and knowledge to properly diagnose and repair the issue to avoid any further complications.
Discuss the causes and fixes for P0031 2013 Nissan Rogue OBDII Code
Code P0031 2013 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
