P0031 2010 Nissan Rogue Code - Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low
Quick Answer
Air-Fuel Ratio (A/F)sensor need to reach a minimum operating temperature of 1200 degrees F to produce an accurate voltage signal. Common causes include Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0031 2010 Nissan Rogue indicates Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit Low.
- Common causes
- Common causes include Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground, Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0031 2010 Nissan Rogue Description
In order to achieve the require temperature, a heater element is included inside the air-fuel ratio sensor. The ECM controls the air-fuel ratio sensor heater element based on signals from the engine coolant temperature and engine load. The ECM controls the heater element circuit by allowing current flow to ground.
The ECM monitors the voltage signal received through the heater element circuit and determines the state of the circuit by comparing the voltage detected with the factory specifications.
What are the Possible Causes of the DTC P0031 2010 Nissan Rogue?
- Faulty Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 harness is open shorted to ground
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit poor electrical connection
- Air-Fuel Ratio (A/F) Sensor Bank 1 Sensor 1 circuit fuse
- Faulty Engine Control Module (ECM)
How to Fix the DTC P0031 2010 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0031 2010 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0031 2010 Nissan Rogue code?
Need more information on how to fix the P0031 2010 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0031 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0031 2010 Nissan Rogue Code
1. What are the common symptoms of OBDII code P0031 on a 2010 Nissan Rogue?
The common symptoms of code P0031 on a 2010 Nissan Rogue may include poor fuel economy, engine misfires, rough idling, and the illumination of the check engine light.
2. What does the OBDII code P0031 on a 2010 Nissan Rogue indicate?
OBDII code P0031 on a 2010 Nissan Rogue indicates an issue with the Air Fuel Ratio Sensor 1 Heater Bank 1 Control Circuit being low.
3. What are the possible causes of OBDII code P0031 on a 2010 Nissan Rogue?
Possible causes of code P0031 on a 2010 Nissan Rogue include a faulty air fuel ratio sensor, damaged wiring or connectors, a blown fuse, or a problem with the engine control module (ECM).
4. How can I diagnose the OBDII code P0031 on my 2010 Nissan Rogue?
To diagnose code P0031 on a 2010 Nissan Rogue, you can use an OBDII scanner to retrieve the code, visually inspect the sensor and its wiring, test the sensor's resistance, and check for any blown fuses.
5. Can I still drive my 2010 Nissan Rogue with OBDII code P0031?
It is not recommended to drive your 2010 Nissan Rogue with code P0031 for an extended period as it can lead to poor engine performance and potential damage if left unresolved.
6. How can I repair OBDII code P0031 on a 2010 Nissan Rogue?
To repair code P0031 on a 2010 Nissan Rogue, you may need to replace the Air Fuel Ratio Sensor 1, repair any damaged wiring or connectors, replace blown fuses, or address any issues with the ECM.
7. Is it necessary to reset the OBDII code P0031 after making repairs on a 2010 Nissan Rogue?
Yes, it is recommended to reset the OBDII code P0031 after making repairs on a 2010 Nissan Rogue to clear the fault code and see if the issue has been successfully resolved.
8. Can a DIY enthusiast fix OBDII code P0031 on a 2010 Nissan Rogue?
Depending on your mechanical skills and experience, a DIY enthusiast may be able to fix code P0031 on a 2010 Nissan Rogue by following repair guides and using the right tools and parts.
9. How much does it cost to repair OBDII code P0031 on a 2010 Nissan Rogue?
The cost to repair code P0031 on a 2010 Nissan Rogue can vary depending on the specific issue, labor rates in your area, and whether you choose to do the repair yourself or take it to a professional mechanic.
10. Will OBDII code P0031 on a 2010 Nissan Rogue affect emissions or vehicle performance?
Yes, OBDII code P0031 on a 2010 Nissan Rogue can affect emissions and vehicle performance by causing the engine to run inefficiently, potentially leading to increased emissions and reduced fuel economy.
Discuss the causes and fixes for P0031 2010 Nissan Rogue OBDII Code
-
hi i have a nissan tiida 2010, in my elm327 v.15 scan tool, i dont get readings from short term fuel trim nor ltft, and my trouble code says p0031 low circuit.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
