AutoCodes – Ford – C1282 Ford

C1282 Ford Code - Lateral Accelerometer Signal Fault

Quick Answer

The yaw rate sensor, roll rate sensor, lateral accelerometer and longitudinal accelerometer are contained in one module called the stability control sensor cluster. Common causes include Faulty Stability Control Sensor Cluster, Stability Control Sensor Cluster harness is open or shorted, Stability Control Sensor Cluster circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: C1282 Ford indicates Lateral Accelerometer Signal Fault.
Common causes: Common causes include Faulty Stability Control Sensor Cluster, Stability Control Sensor Cluster harness is open or shorted, Stability Control Sensor Cluster circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 7,859

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Sep 02, 2020

Description
Possible Causes
How To Fix
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code C1282 Ford Description

The yaw rate sensor, roll rate sensor, lateral accelerometer and longitudinal accelerometer are contained in one module called the stability control sensor cluster. The sensor cluster measures the vehicle acceleration, roll rate and yaw rate, then sends the signal through a secondary, dedicated controller area network (CAN2) bus to the ABS module. The ABS module compares the information from the sensor cluster to information it receives from other sensors (brake pedal input or steering wheel rotation sensor) to determine how valid the information is and to determine if a roll-over event is about to occur.
The ABS module provides power to the sensor cluster and ground. The sensor cluster and the ABS module communicate. An open circuit or a short to power or ground on any one of these 4 circuits will cause the ABS module to set a DTC. Also, if the sensor cluster is not mounted in the correct position, with the electrical connector facing the passenger seat, the ABS module will also set DTCs.

OBDII Code C1282 Ford - Lateral Accelerometer Signal Fault - AutoCodes.com — C1282 Ford Code - Lateral Accelerometer Signal Fault

What does this mean?

What are the Possible Causes of the DTC C1282 Ford?

Faulty Stability Control Sensor Cluster
Stability Control Sensor Cluster harness is open or shorted
Stability Control Sensor Cluster circuit poor electrical connection

How to Fix the DTC C1282 Ford?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the C1282 Ford code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the C1282 Ford code?

Need more information on how to fix the C1282 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the C1282 Ford code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.