C0760 2014 Chevrolet Silverado Code - Left Rear Low Tire Pressure Sensor
Quick Answer
The Tire Pressure Monitor System (TPMS) has a Radio Frequency (RF) transmitting pressure sensor in each wheel/tire assembly. Common causes include Perform the Tire Pressure Indicator Sensor Learn, Faulty Left Rear Low Tire Pressure Sensor, Left Rear Low Tire Pressure Sensor harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- C0760 2014 Chevrolet Silverado indicates Left Rear Low Tire Pressure Sensor.
- Common causes
- Common causes include Perform the Tire Pressure Indicator Sensor Learn, Faulty Left Rear Low Tire Pressure Sensor, Left Rear Low Tire Pressure Sensor harness is open or shorted.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code C0760 2014 Chevrolet Silverado Description
What are the Possible Causes of the DTC C0760 2014 Chevrolet Silverado?
- Perform the Tire Pressure Indicator Sensor Learn
- Faulty Left Rear Low Tire Pressure Sensor
- Left Rear Low Tire Pressure Sensor harness is open or shorted
- Left Rear Low Tire Pressure Sensor circuit poor electrical connection
How to Fix the DTC C0760 2014 Chevrolet Silverado?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
Some aftermarket wheel valve stem holes are located further from the wheel rim than the original equipment wheels. When using the tire pressure monitor special tool to activate a sensor, ensure the tool is placed along the tire sidewall and no further than 15 cm (6 in) from the sensor and the antenna is aiming upward.
Occasionally sensors can become mislocated due to previous tire rotations where the sensor learn procedure was not performed. Always learn the sensors to ensure the DTC set is for that actual physical corner of the vehicle.
A sensor with low battery condition will set a sensor DTC but will not illuminate the low tire pressure indicator or display a message on the driver information center if equipped. The sensor battery condition can be verified in the scan tool BCM data list. If a sensor's low battery condition is indicated on the scan tool, the sensor will need to be replaced.
User Submitted Video
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the C0760 2014 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the C0760 2014 Chevrolet Silverado code?
Need more information on how to fix the C0760 2014 Chevrolet Silverado code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the C0760 2014 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about C0760 2014 Chevrolet Silverado Code
1. What does the OBDII code C0760 mean on a 2014 Chevrolet Silverado?
The code C0760 indicates an issue with the left rear tire pressure sensor, typically involving low tire pressure or a fault in the sensor itself.
2. What are the common symptoms of code C0760 in a 2014 Chevy Silverado?
Symptoms include a tire pressure warning light on the dashboard, inaccurate tire pressure readings, or no reading from the left rear tire.
3. What causes code C0760 in the 2014 Chevrolet Silverado?
Common causes include an actual low tire pressure, a faulty tire pressure sensor, damaged wiring, or interference with the sensor signal.
4. How do I fix the C0760 code on my 2014 Chevy Silverado?
First, check and inflate the left rear tire to the recommended pressure. If the issue persists, inspect or replace the tire pressure sensor and check the wiring connections.
5. Can I drive my 2014 Silverado with a C0760 code active?
Yes, but it's not recommended for long periods, as incorrect tire pressure can affect handling, fuel efficiency, and tire longevity.
6. How do I reset the tire pressure monitoring system (TPMS) after fixing C0760?
After inflating all tires to the correct pressure, use the TPMS reset tool or follow the TPMS relearn procedure in your Silverado's owner's manual.
7. How much does it cost to replace a faulty tire pressure sensor in a 2014 Chevrolet Silverado?
The cost of replacing a tire pressure sensor typically ranges from $50 to $150 per sensor, depending on labor and parts.
8. Can bad weather or cold temperatures trigger the C0760 code?
Yes, cold weather can lower tire pressure, potentially triggering the code. Check and adjust tire pressure during temperature changes.
9. How can I check if the left rear tire pressure sensor is faulty?
Use an OBDII scanner with TPMS functionality to test the sensor's signal or consult a mechanic for diagnosis.
10. What is the recommended tire pressure for a 2014 Chevrolet Silverado?
The recommended tire pressure is usually listed on a sticker inside the driver's doorframe and is typically around 35 PSI, but check your specific model for accuracy.
Discuss the causes and fixes for C0760 2014 Chevrolet Silverado OBDII Code
Code C0760 2014 Chevrolet Silverado comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
