C0292 Buick Code - EBCM Failed To Receive Serial Data From PCM
Quick Answer
The Powertrain Control Module (PCM) sends a state of health message to the Electronic Brake Control Module (EBCM) within 5.5 seconds after the modules are powered up. Common causes include Electronic Brake Control Module (EBCM) Calibration, Faulty Electronic Brake Control Module (EBCM), Electronic Brake Control Module (EBCM) harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- C0292 Buick indicates EBCM Failed To Receive Serial Data From PCM.
- Common causes
- Common causes include Electronic Brake Control Module (EBCM) Calibration, Faulty Electronic Brake Control Module (EBCM), Electronic Brake Control Module (EBCM) harness is open or shorted.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code C0292 Buick Description
What are the Possible Causes of the DTC C0292 Buick?
- Electronic Brake Control Module (EBCM) Calibration
- Faulty Electronic Brake Control Module (EBCM)
- Electronic Brake Control Module (EBCM) harness is open or shorted
- Electronic Brake Control Module (EBCM) circuit poor electrical connection
How to Fix the DTC C0292 Buick?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the C0292 Buick code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the C0292 Buick code?
Need more information on how to fix the C0292 Buick code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the C0292 Buick code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about C0292 Buick Code
1. What does the OBDII code C0292 mean on a Buick?
The code C0292 indicates that the Electronic Brake Control Module (EBCM) has failed to receive serial data communication from the Powertrain Control Module (PCM).
2. What are the symptoms of the C0292 code on a Buick?
Common symptoms include the ABS warning light being illuminated, traction control being disabled, and potentially a loss of communication between modules.
3. What causes the C0292 code to appear on a Buick?
Possible causes include wiring or connection issues between the EBCM and PCM, a faulty EBCM, a faulty PCM, or a communication bus failure.
4. Can a bad EBCM cause the C0292 code?
Yes, a malfunctioning EBCM can prevent proper communication with the PCM, triggering the C0292 code.
5. How do I diagnose the C0292 code on my Buick?
Use a scan tool to check for related codes, inspect the wiring and connectors between the EBCM and PCM, and test the communication bus for faults.
6. Can I drive my Buick with the C0292 code active?
While the vehicle may still be drivable, safety systems like ABS and traction control may be compromised, so it’s recommended to address the issue promptly.
7. How is the C0292 code repaired on a Buick?
Repairs may involve fixing damaged wiring, replacing faulty connectors, reprogramming or replacing the EBCM or PCM, or addressing communication bus issues.
8. Does the C0292 code always mean the EBCM is bad on a Buick?
No, the issue could also be caused by wiring problems, a faulty PCM, or communication failures, so proper diagnosis is essential.
9. What tools are needed to fix the C0292 code on a Buick?
A diagnostic scan tool, multimeter, wiring diagram, and potentially programming equipment for reprogramming the EBCM or PCM may be required.
10. How much does it cost to fix the C0292 code on a Buick?
Repair costs can vary, typically ranging from $100 to $1,000, depending on whether wiring repairs, module replacements, or reprogramming are needed.
Discuss the causes and fixes for C0292 Buick OBDII Code
Code C0292 Buick comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
