B1482 KIA Code - 2nd Stage Driver Airbag Resistance Too Low
Quick Answer
The Driver Airbag circuit consists of the Supplemental Restraints System Control Module (SRSCM), Clockspring and the Driver Airbag (DAB) which has two squib circuits. Common causes include Faulty Driver Airbag, Driver Airbag harness is open or shorted, Driver Airbag circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- B1482 KIA indicates 2nd Stage Driver Airbag Resistance Too Low.
- Common causes
- Common causes include Faulty Driver Airbag, Driver Airbag harness is open or shorted, Driver Airbag circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code B1482 KIA Description
What are the Possible Causes of the DTC B1482 KIA?
- Faulty Driver Airbag
- Driver Airbag harness is open or shorted
- Driver Airbag circuit poor electrical connection
- Faulty Clockspring
- Faulty Supplemental Restraints System Control Module (SRSCM)
How to Fix the DTC B1482 KIA?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B1482 KIA code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the B1482 KIA code?
Need more information on how to fix the B1482 KIA code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the B1482 KIA code diagnosed by a professional: Find a repair shop in your area
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Frequently Asked Questions about B1482 KIA Code
1. What are the common symptoms of OBDII code B1482 in a KIA vehicle?
- The common symptoms include the airbag warning light illuminated on the dashboard and a diagnostic trouble code indicating "2nd Stage Driver Airbag Resistance Too Low."
2. What could cause the OBDII code B1482 to appear in my KIA?
- The code B1482 typically indicates that there is an issue with the 2nd stage driver airbag system, often caused by a fault in the airbag circuit or a problem with the airbag itself.
3. How serious is the 2nd Stage Driver Airbag Resistance Too Low fault in a KIA?
- This fault is a safety concern as it indicates that the driver airbag may not deploy correctly in the event of a collision, potentially increasing the risk of injury to the driver.
4. Can I continue driving my KIA with the B1482 code present?
- It is not recommended to drive the vehicle with the B1482 code present, as the driver airbag system may not function properly in the event of an accident.
5. How can I troubleshoot and repair the 2nd Stage Driver Airbag Resistance Too Low issue in my KIA?
- To diagnose and repair the B1482 code, it is advisable to consult a qualified mechanic or dealership with the necessary tools and expertise to inspect the airbag system thoroughly.
6. Is it possible to reset the B1482 code in my KIA without addressing the underlying issue?
- While clearing the diagnostic trouble code may temporarily turn off the warning light, the underlying issue causing the B1482 code will persist and should be addressed to ensure the safety of the airbag system.
7. Are there any DIY repair tips for fixing the 2nd Stage Driver Airbag Resistance Too Low fault in a KIA?
- Due to the complexity and safety implications of airbag systems, it is recommended to leave the diagnosis and repair of the B1482 code to trained professionals to ensure proper functioning of the airbag system.
8. How much does it typically cost to repair the 2nd Stage Driver Airbag Resistance Too Low fault in a KIA?
- The cost of repairing the B1482 code can vary depending on the specific issue causing the fault, parts needed for replacement, and labor charges. It is best to get a detailed estimate from a qualified technician.
9. Can the B1482 code be triggered by a faulty sensor or wiring issue in the airbag system?
- Yes, the B1482 code can be triggered by faulty sensors, wiring issues, or a malfunctioning airbag module within the 2nd stage driver airbag system.
10. How long does it typically take to fix the 2nd Stage Driver Airbag Resistance Too Low fault in a KIA?
- The repair time for the B1482 code can vary depending on the exact cause of the fault and the availability of parts. In some cases, it may require a few hours to diagnose and repair the issue, while more complex problems may take longer to resolve.
Discuss the causes and fixes for B1482 KIA OBDII Code
-
I changed the clockspring as I got code B1481 and B1482. Made some phone calls to automotive electrical technicians after trying to clear with Foxwell elite. They said you have to have the Kia million dollar scanner to reset SCRSM or the SRS computer and that a generic scanner won't clear it. So called the KIA dealership and diagnostics is $195+tax not $75-$150.
So before you spend more and more money take it to the dealer for diagnosis. Will update when I find out what the dealer says.
-
Thank you for your feedback! We will make the necessary changes to clarify the estimate.
-
Got back from the dealership and some how my airbag has shorted out. $1100 new and $100-$150 at most wrecking yards
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
