AutoCodes – Chevrolet – B0087 2018 Chevrolet Silverado

B0087 2018 Chevrolet Silverado Code - Left Rear Side Impact Sensor

Quick Answer

The impact sensors are equipped on vehicles to supplement the supplemental inflatable restraint (SIR) system performance. Common causes include Faulty Left Rear Side Impact Sensor, Left Rear Side Impact Sensor harness is open or shorted, Left Rear Side Impact Sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: B0087 2018 Chevrolet Silverado indicates Left Rear Side Impact Sensor.
Common causes: Common causes include Faulty Left Rear Side Impact Sensor, Left Rear Side Impact Sensor harness is open or shorted, Left Rear Side Impact Sensor circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 602

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Oct 24, 2022

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code B0087 2018 Chevrolet Silverado Description

The impact sensors are equipped on vehicles to supplement the supplemental inflatable restraint (SIR) system performance. The impact sensors are electronic and are not part of the deployment loops, but instead provide inputs to the Inflatable Restraint Sensing and Diagnostic Module (SDM). The impact sensors can assist in determining the severity of some frontal and side collisions. The Inflatable Restraint Sensing and Diagnostic Module use the input from the impact sensors to assist in determining the severity of a collision, further supporting air bag deployment. If the Inflatable Restraint Sensing and Diagnostic Module determines a deployment is warranted, the Inflatable Restraint Sensing and Diagnostic Module will cause current to flow through the deployment loops deploying the air bags.

OBDII Code B0087 2018 Chevrolet Silverado - Left Rear Side Impact Sensor - AutoCodes.com — B0087 2018 Chevrolet Silverado Code - Left Rear Side Impact Sensor

What does this mean?

What are the Possible Causes of the DTC B0087 2018 Chevrolet Silverado?

Faulty Left Rear Side Impact Sensor
Left Rear Side Impact Sensor harness is open or shorted
Left Rear Side Impact Sensor circuit poor electrical connection
Faulty Inflatable Restraint Sensing and Diagnostic Module (SDM)

How to Fix the DTC B0087 2018 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

B0087:02 Left Rear Side Impact Sensor Short to Ground
B0087:05 Left Rear Side Impact Sensor High Voltage/Open
B0087:39 Left Rear Side Impact Sensor Internal Malfunction
B0087:3A Left Rear Side Impact Sensor Incorrect Component Installed
B0087:71 Left Rear Side Impact Sensor Invalid Data

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B0087 2018 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the B0087 2018 Chevrolet Silverado code?

Need more information on how to fix the B0087 2018 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B0087 2018 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about B0087 2018 Chevrolet Silverado Code

1. What does the OBDII code B0087 indicate on a 2018 Chevrolet Silverado?

The code B0087 indicates a fault in the Left Rear Side Impact Sensor circuit, suggesting that the sensor or its circuit is malfunctioning.

2. What symptoms might I notice if my 2018 Chevrolet Silverado has the B0087 code?

Symptoms can include the airbag warning light illuminating on the dashboard and possibly the airbags not deploying correctly in the event of a side impact crash.

3. What can cause the B0087 code to appear on a 2018 Chevrolet Silverado?

Common causes include damaged wiring or connectors, a faulty left rear side impact sensor, or issues with the airbag control module.

4. How can I fix the B0087 code on my 2018 Chevrolet Silverado?

Repairs might involve inspecting and repairing or replacing the wiring and connectors, replacing the faulty side impact sensor, or repairing issues with the airbag control module.

5. Is it safe to drive my 2018 Chevrolet Silverado with the B0087 code?

While the vehicle can be driven, safety is compromised as the airbag system may not function properly in a crash. It's advisable to address the issue promptly.

6. How do I diagnose the B0087 code in a 2018 Chevrolet Silverado?

Diagnosis involves using a scan tool to read the fault code and examining the wiring and connectors for damage. Testing the sensor and the airbag control module functionality with specialized tools may also be necessary.

7. Could the B0087 code affect other systems in my 2018 Chevrolet Silverado?

Although primarily impacting the airbag system, unresolved issues with side impact sensors can potentially cause errors in other systems that rely on sensor inputs for safety features.

8. What tools are needed to repair the issue causing the B0087 code in a 2018 Chevrolet Silverado?

Tools needed might include a digital multimeter for electrical testing, a scan tool for diagnostics, and basic hand tools for accessing and replacing components.

9. How much might it cost to fix the B0087 code in a 2018 Chevrolet Silverado?

Costs can vary widely depending on the specific repair needed, but typically range from $100 for minor wiring repairs to over $500 if replacing the side impact sensor or airbag control module is necessary.