AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - C276C

C276C Code - Incorrect Longitudinal Acceleration Sensor Out of Calibration

- Code Popularity: 938 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC C276C?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Stability Control Sensor Cluster
  • Stability Control Sensor Cluster harness is open or shorted
  • Stability Control Sensor Cluster circuit poor electrical connection
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC C276C?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for C276C Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the C276C code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

Code C276C Description

The yaw rate sensor, roll rate sensor, lateral accelerometer and longitudinal accelerometer are contained in one module called the stability control sensor cluster. The sensor cluster measures the vehicle acceleration, roll rate and yaw rate, then sends the signal through a secondary, dedicated controller area network (CAN2) bus to the ABS module. The ABS module compares the information from the sensor cluster to information it receives from other sensors (brake pedal input or steering wheel rotation sensor) to determine how valid the information is and to determine if a roll-over event is about to occur.
The ABS module provides power to the sensor cluster and ground. The sensor cluster and the ABS module communicate. An open circuit or a short to power or ground on any one of these 4 circuits will cause the ABS module to set a DTC. Also, if the sensor cluster is not mounted in the correct position, with the electrical connector facing the passenger seat, the ABS module will also set DTCs.

OBDII Code C276C - Incorrect Longitudinal Acceleration Sensor Out of Calibration - AutoCodes.com
C276C Code - Incorrect Longitudinal Acceleration Sensor Out of Calibration

Need More Information on the Code?

Need more information on how to fix the C276C code? Get Access to Factory Service Manuals

Information for Specific Makes

  • C276C Ford Incorrect Longitudinal Acceleration Sensor Out of Calibration
  • C276C Lincoln Incorrect Longitudinal Acceleration Sensor Out of Calibration
  • C276C Mercury Incorrect Longitudinal Acceleration Sensor Out of Calibration

Need Help with the Code?

Get the C276C code diagnosed by a professional: Find a repair shop in your area

Code C276C comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the C276C code? Have you replaced any parts?
Any information is appreciated. Thanks