AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - C1445 Toyota

C1445 Toyota Code - Vehicle Driven with Steering Angle Sensor not Initialized

- Code Popularity: 7,065 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC C1445 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Steering Angle Sensor
  • Steering Angle Sensor harness is open or shorted
  • Steering Angle Sensor circuit poor electrical connection
  • Yaw Rate and Acceleration Sensor (for separate type)
  • Yaw Rate and Acceleration Sensor (Airbag sensor assembly) (for built-in type)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC C1445 Toyota?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for C1445 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the C1445 Toyota code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

Code C1445 Toyota Description

The Skid Control ECU (Brake Actuator Assembly) acquires a steering sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point. The steering sensor zero point malfunction warning is canceled by turning the ignition switch off. The Diagnostic Trouble Code (DTC) will be when the steering sensor zero point calibration cannot be obtained when the vehicle is driven without a record of steering sensor zero point calibration at a speed of 35 km/h (22 mph) or more for 30 seconds or more without the brake pedal being depressed.

OBDII Code C1445 Toyota - Vehicle Driven with Steering Angle Sensor not Initialized - AutoCodes.com
C1445 Toyota Code - Vehicle Driven with Steering Angle Sensor not Initialized

Need More Information on the Code?

Need more information on how to fix the C1445 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the C1445 Toyota code diagnosed by a professional: Find a repair shop in your area

Code C1445 Toyota comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the C1445 Toyota code? Have you replaced any parts?
Any information is appreciated. Thanks