AutoCodes.com | All About OBDII Engine Codes
AutoCodes - KIA - C1261 KIA

C1261 KIA Code - Steering Angle Sensor Not Calibrated

- Code Popularity: 26,847 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC C1261 KIA?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Steering Angle Sensor(SAS) not calibrated
  • Faulty Steering Angle Sensor(SAS)
  • Steering Angle Sensor(SAS) harness is open or shorted
  • Steering Angle Sensor(SAS) circuit poor electrical connection
⚠ Does your KIA have Safety Recalls? → Check here

How to Fix the DTC C1261 KIA?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for C1261 KIA Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the C1261 KIA code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The SAS used for ESC control needs 0 set because the SAS measures an absolute angle. 0 set is done by using the scantool device. If abnormal 0 set is detected or no information in SAS is detected, a failure is recognized.

What are Code Possible Symptoms?

  • Anti-Lock Brake System (ABS) Warning Light ON
  • Engine Light ON (or Service Engine Soon Warning Light)

Code C1261 KIA Description

The Steering Angle Sensor(SAS) is installed below the clock spring and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction and speed of the steering wheel. The HECU uses the signals from the SAS when performing ESC-related calculations.

OBDII Code C1261 KIA - Steering Angle Sensor Not Calibrated - AutoCodes.com
C1261 KIA Code - Steering Angle Sensor Not Calibrated

Need More Information on the Code?

Need more information on how to fix the C1261 KIA code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the C1261 KIA code diagnosed by a professional: Find a repair shop in your area

Code C1261 KIA comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the C1261 KIA code? Have you replaced any parts?
Any information is appreciated. Thanks