AutoCodes – Buick – B3855 Buick

B3855 Buick Code - Rollover Sensor Performance

Quick Answer

The inflatable restraint vehicle Rollover Sensor (ROS) utilizes the battery power supply and a bidirectional interface circuit. Common causes include Faulty Rollover Sensor, Rollover Sensor harness is open or shorted, Rollover Sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: B3855 Buick indicates Rollover Sensor Performance.
Common causes: Common causes include Faulty Rollover Sensor, Rollover Sensor harness is open or shorted, Rollover Sensor circuit poor electrical connection.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 585

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Mar 23, 2020

Description
Possible Causes
How To Fix
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code B3855 Buick Description

The inflatable restraint vehicle Rollover Sensor (ROS) utilizes the battery power supply and a bidirectional interface circuit. The ROS modulates current on the interface to send ID, State of Health, and deployment commands to the inflatable restraint Sensing and Diagnostic Module (SDM). When the ignition is turned on the ROS responds by performing internal diagnostics and sending an ID to the SDM. The ROS continually communicates status messages to the SDM, which determines if a fault is present in the ROS circuit. If the fault is present, the SDM will set a Diagnostic Trouble Code (DTC).

OBDII Code B3855 Buick - Rollover Sensor Performance - AutoCodes.com — B3855 Buick Code - Rollover Sensor Performance

What does this mean?

What are the Possible Causes of the DTC B3855 Buick?

Faulty Rollover Sensor
Rollover Sensor harness is open or shorted
Rollover Sensor circuit poor electrical connection
Faulty Sensing and Diagnostic Module (SDM)

How to Fix the DTC B3855 Buick?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B3855 Buick code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the B3855 Buick code?

Need more information on how to fix the B3855 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B3855 Buick code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.

Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.