AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B2805

B2805 Code - No transmitters Programmed

- Code Popularity: 1,076 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2805?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Program transmitters
  • Faulty Remote control door lock receiver
  • Remote control door lock receiver harness is open or shorted
  • Remote control door lock receiver circuit poor electrical connection
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC B2805?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B2805 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2805 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B2805 Description

When a receiver is replaced, all transmitters must be programmed to a new electronic door lock receiver. DTC will remain current until at least one transmitter is programmed. Up to 3 identification codes can be stored by the receiver.
The Diagnostic Trouble Code (DTC) B2805 will set and store in receiver memory when the electronic door lock receiver indicates no transmitter Vehicle Access Code (VAC) has been programmed. No driver warning message will be displayed for this DTC.
The DTC B2805 will automatically clear when the electronic door lock receiver has indicated a valid VAC was programmed properly.

OBDII Code B2805 - No transmitters Programmed - AutoCodes.com
B2805 Code - No transmitters Programmed

Need More Information on the Code?

Need more information on how to fix the B2805 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the B2805 code diagnosed by a professional: Find a repair shop in your area

Code B2805 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2805 code? Have you replaced any parts?
Any information is appreciated. Thanks