☰
AutoCodes.com | All About OBDII Engine Codes
Find a Shop |  Search Codes
AutoCodes - Generic - B2444

B2444 Code - Driver Side Crash Sensor Internal Fault

- Code Popularity: 5,066 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
What is this?
Table of contents
By AutoCodes.com - Updated Dec 08, 2019
Share on Facebook   Share on Twitter   Share on Linkedin
What does this mean?

|Code B2444 Possible Causes

  • Faulty Driver Side Crash Sensor
  • Driver Side Crash Sensor harness is open or shorted
  • Driver Side Crash Sensor circuit poor electrical connection
  • Faulty Air Bag Control Module

|How do I Fix the Code B2444?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Car have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B2444?

Labor: 1.0

The cost of diagnosing the B2444 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B2444 Possible Symptoms?

  • Air Bag Warning Light ON

|Code B2444 Description

The Air Bag Control Module monitors the Driver Side Crash Sensor. The Air Bag Control Module sets the OBDII code when the Driver Side Crash Sensor is not to factory specifications.

OBDII Code B2444 - Driver Side Crash Sensor Internal Fault - AutoCodes.com
B2444 Code - Driver Side Crash Sensor Internal Fault
Search B2444 Questions and Answers →

|Need More Information on the B2444 Code?

Need more information on how to fix the B2444 code? Get Access to Factory Service Manuals

|Need Help with the B2444 Code?

Get the B2444 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Related Information

|Code B2444 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2444 code? Have you replaced any parts?
Any information is appreciated. Thanks