AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Buick - B2355 Buick

B2355 Buick Code - Driver Seat Front Vertical Position Sensor Circuit

- Code Popularity: 639 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2355 Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Driver Seat Front Vertical Motor
  • Driver Seat Front Vertical Motor harness is open or shorted
  • Driver Seat Front Vertical Motor circuit poor electrical connection
  • Faulty Driver Seat Memory Control Module
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC B2355 Buick?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

B1855:01 Driver Seat Front Vertical Position Sensor Circuit Short to Battery
B1855:02 Driver Seat Front Vertical Position Sensor Circuit Short to Ground
B1855:06 Driver Seat Front Vertical Position Sensor Circuit Low Voltage/Open

Search for B2355 Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2355 Buick code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B2355 Buick Description

The Seat Memory Control Module monitors the position of the seat motors by using hall effect position sensors which are an internal part of each motor. The module supplies each sensor with a 12 V reference circuit only when any seat motor is active, and a low side signal circuit. During seat motor operation, the hall effect position sensor provides a determined number of pulse signals for every revolution of the motor shaft. The scan tool displays these pulse signals as counts that range from 0–65,535. The module counts the feedback pulses from each sensor to determine seat position and end-of-travel limits for each of the seat motors. High scan tool count values indicate forward or upward seat positions while low count values indicate rearward or downward seat positions. The Diagnostic Trouble Code (DTC) will be set when there is a fault in the Driver Seat Front Vertical Position Sensor Circuit.

OBDII Code B2355 Buick - Driver Seat Front Vertical Position Sensor Circuit - AutoCodes.com
B2355 Buick Code - Driver Seat Front Vertical Position Sensor Circuit

Need More Information on the Code?

Need more information on how to fix the B2355 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B2355 Buick code diagnosed by a professional: Find a repair shop in your area

Code B2355 Buick comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2355 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks