AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jaguar - B2296 Jaguar

B2296 Jaguar Code - Restraint System Impact Sensor Fault

- Code Popularity: 4,478 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2296 Jaguar?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Impact Sensor
  • Impact Sensor harness is open or shorted
  • Impact Sensor circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)
⚠ Does your Jaguar have Safety Recalls? → Check here

How to Fix the DTC B2296 Jaguar?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B2296 Jaguar Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2296 Jaguar code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B2296 Jaguar Description

The Restraints Control Module (RCM) continuously communicates with all impact sensors for external and internal sensor data. The RCM also continuously monitors all of the impact sensor circuits for a short to voltage, short to ground and open circuits. If the RCM detects any communication or circuit faults with any of the impact sensors, it will store DTC B2296 in memory and send a message to the instrument cluster (IC) module to illuminate the air bag warning indicator.

OBDII Code B2296 Jaguar - Restraint System Impact Sensor Fault - AutoCodes.com
B2296 Jaguar Code - Restraint System Impact Sensor Fault

Need More Information on the Code?

Need more information on how to fix the B2296 Jaguar code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B2296 Jaguar code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B2296 Jaguar comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2296 Jaguar code? Have you replaced any parts?
Any information is appreciated. Thanks