AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jaguar - B2290 Jaguar

B2290 Jaguar Code - Occupant Classification System Fault

- Code Popularity: 3,988 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2290 Jaguar?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Occupant Classification System Module (OCSM)
  • Occupant Classification System Module (OCSM) harness is open or shorted
  • Occupant Classification System Module (OCSM) circuit poor electrical connection
⚠ Does your Jaguar have Safety Recalls? → Check here

How to Fix the DTC B2290 Jaguar?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B2290 Jaguar Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2290 Jaguar code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B2290 Jaguar Description

The Occupant Classification System Module (OCSM) monitors the pressure sensor and circuity for faults. If a fault is detected, the OCSM will store DTC B2290 in memory and send a message to the Restraints Control Module (RCM).

OBDII Code B2290 Jaguar - Occupant Classification System Fault - AutoCodes.com
B2290 Jaguar Code - Occupant Classification System Fault

Need More Information on the Code?

Need more information on how to fix the B2290 Jaguar code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B2290 Jaguar code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B2290 Jaguar comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2290 Jaguar code? Have you replaced any parts?
Any information is appreciated. Thanks