B2208 CHRYSLER - Occupant Restraint Controller Internal 2
B2208 Chrysler DescriptionWhen powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault condition does not involve any external circuitry and centers on verifying the integrity of the module's internal circuitry and software validity.
When Monitored the ORC checks the status and validity of the internal operating hardware and software at power up during the initialization process, and continuing through the ignition cycle.
Set Condition this DTC sets when a fault is detected internal to ORC hardware and/or software. Once set, this DTC is latched for the entire power cycle. If the same failure is detected in two consecutive power cycles, this DTC is latched active indefinitely.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Need more help?Do you need more help with the B2208 Chrysler code? Ask a question to our users or find an automotive repair shop near you to help fix the OBDII code
B2208 CHRYSLER CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B2208 Chrysler code? Have you replaced any parts?
Any information is appreciated. Thanks