B2119 NISSAN - Steering Column Telescopic Sensor
B2119 Nissan DescriptionThe telescopic sensor is installed to the steering column assembly.
The resistance of the telescopic sensor is changed according to the forward/backward position of the steering column.
The terminal voltage of automatic drive positioner control unit will be changed according to a change of telescopic sensor resistance. Automatic drive positioner control unit calculates the telescopic position from the voltage.
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Need more help?Do you need more help with the B2119 Nissan code? Ask a question to our users or find an automotive repair shop near you to help fix the OBDII code
B2119 NISSAN CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B2119 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks