AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B2006

B2006 Code - Short To Ground In Seat Belt Motor Left Circuit

- Code Popularity: 1,086 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B2006?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Front Seat Outer Belt Assembly Left (LH)
  • Front Seat Outer Belt Assembly Left (LH) harness is open or shorted
  • Front Seat Outer Belt Assembly Left (LH) circuit poor electrical connection
  • Faulty Seat Belt Control ECU
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC B2006?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B2006 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B2006 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B2006 Description

The Seat Belt Control ECU receives information from the master cylinder solenoid (Skid Control ECU) via the Controlled Are Network (CAN) communication line and tightens the seat belt by operating the motor in the Front Seat Outer Belt Assembly Right (RH) or Left (LH). The Seat Belt Control ECU sets the OBDII code if there is a short in the seat belt motor LF circuit.

OBDII Code B2006 - Short To Ground In Seat Belt Motor Left Circuit - AutoCodes.com
B2006 Code - Short To Ground In Seat Belt Motor Left Circuit

Need More Information on the Code?

Need more information on how to fix the B2006 code? Get Access to Factory Service Manuals

Information for Specific Makes

  • B2006 Lexus Short To Ground In Seat Belt Motor Left Circuit
  • B2006 Scion Short To Ground In Seat Belt Motor Left Circuit
  • B2006 Toyota Short To Ground In Seat Belt Motor Left Circuit

Need Help with the Code?

Get the B2006 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B2006 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B2006 code? Have you replaced any parts?
Any information is appreciated. Thanks