⚠ Does your Mitsubishi have Safety Recalls? → Check here
How to Fix the DTC B1BC7 Mitsubishi?
Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
Search for B1BC7 Mitsubishi Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B1BC7 Mitsubishi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Air Bag Warning Light ON
Code B1BC7 Mitsubishi Description
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault condition does not involve any external circuitry and centers on verifying the integrity of the module's internal memory. The ORC checks its internal memory for the number of recorded deployment events once at every power up, during the initialization process. This Diagnostic Trouble Code (DTC) sets when the ORC detects that five recorded deploy events have been reached. Once set, this DTC is latched indefinitely.
B1BC7 Mitsubishi Code - Deployment Data Record Full
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1BC7 Mitsubishi code? Have you replaced any parts? Any information is appreciated. Thanks