AutoCodes
 
OBDII Code List
 
B1B2D DODGE

B1B2D DODGE - 1st Row Passenger Seat Belt Pretensioner Circuit High

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

B1B2D DODGE Possible Causes

  • Faulty Passenger Seat Belt Pretensioner
  • Passenger Seat Belt Pretensioner harness is open or shorted
  • Passenger Seat Belt Pretensioner circuit poor electrical connection
  • Faulty Occupant Restraint Controller (ORC)

First diagnose B1B2D DODGE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1B2D DODGE code

    Labor: 1.0

    The cost of diagnosing the B1B2D DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

B1B2D DODGE Possible Symptoms

  • Air Bag Warning Light ON

B1b2d Dodge Description

The Occupant Restraint Controller (ORC) monitors the 1st Row Passenger Seat Belt Pretensioner Circuit. The OBDII code sets when the ORC detects voltage on the Passenger Seat Belt Tensioner circuits.
OBDII Code B1b2d Dodge - 1st Row Passenger Seat Belt Pretensioner Circuit High - AutoCodes.com

B1B2D DODGE More Information

Need more information on how to fix the B1B2D DODGE code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1b2d Dodge code diagnosed by a professional: Find a repair shop in your area

Related Information

B1B2D DODGE Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1b2d Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧