OBDII Code List

B1B1A DODGE - Left Side Curtain Squib 1 Circuit Open

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

B1B1A DODGE Possible Causes

  • Faulty Left Side Curtain Squib 1
  • Left Side Curtain Squib 1 harness is open or shorted
  • Left Side Curtain Squib 1 circuit poor electrical connection
  • Faulty Left Side Curtain Airbag
  • Faulty Occupant Restraint Controller (ORC)

First diagnose B1B1A DODGE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1B1A DODGE code

    Labor: 1.0

    The cost of diagnosing the B1B1A DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the B1B1A DODGE code detected?

This Diagnostic Trouble Code (DTC) sets when the ORC detects an open or high resistance on the left squib circuit for more than 2.5 seconds. This DTC transitions from active to stored when the ORC sees a recovery from an open condition for greater than 2.5 seconds.

B1B1A DODGE Possible Symptoms

  • Air Bag Warning Light ON

B1b1a Dodge Description

When powered, the Occupant Restraint Controller (ORC) sends a test current to the squibs to verify the integrity of the squib and wiring. These circuits are maintained in a floating configuration at the module (connected to neither power nor ground) as protection against inadvertent deployment. The use of the Supplemental Restraint System (SRS) Load Tool Adapter Tool provides a test point as well as a method for opening the shorting bar connections within the harness connector. The ORC sends out a 40 mA diagnostic current on each squib voltage supply circuit at power up and every 500 ms thereafter while the ignition is on.
OBDII Code B1b1a Dodge - Left Side Curtain Squib 1 Circuit Open -

B1B1A DODGE More Information

Need more information on how to fix the B1B1A DODGE code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1b1a Dodge code diagnosed by a professional: Find a repair shop in your area

Related Information

B1B1A DODGE Comments

Help us improve Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1b1a Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧