AutoCodes - OBDII Code List - B1B19 DODGE

B1B19 DODGE - Left Side Curtain Squib 1 Circuit High

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

B1B19 DODGE Possible Causes

  • Faulty Left Side Curtain Squib 1
  • Left Side Curtain Squib 1 harness is open or shorted
  • Left Side Curtain Squib 1 circuit poor electrical connection
  • Faulty Left Side Curtain Airbag
  • Faulty Occupant Restraint Controller (ORC)

How do I fix code B1B19 DODGE?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Cost of diagnosing the B1B19 DODGE code

Labor: 1.0

The cost of diagnosing the B1B19 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

This Diagnostic Trouble Code (DTC) sets when the ORC detects a short to voltage on the left side squib circuit for more than 2.5 seconds. This DTC transitions from active to stored when the ORC sees a recovery from a short to voltage for greater than 2.5 seconds.

Possible Symptoms

  • Air Bag Warning Light ON

B1B19 DODGE Description

When powered, the Occupant Restraint Controller (ORC) sends a test current to the squibs to verify the integrity of the squib and wiring. These circuits are maintained in a floating configuration at the module (connected to neither power nor ground) as protection against inadvertent deployment. The use of the Supplemental Restraint System (SRS) Load Tool Adapter Tool provides a test point as well as a method for opening the shorting bar connections within the harness connector. The ORC sends out a 40 mA diagnostic current on each squib voltage supply circuit at power up and every 500 ms thereafter while the ignition is on.
OBDII Code B1b19 Dodge - Left Side Curtain Squib 1 Circuit High - AutoCodes.com

More Information

Need more information on how to fix the B1B19 DODGE code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1b19 Dodge code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1b19 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧