OBDII Code List

B1A09 LINCOLN - Speaker 9 General Electric Failure

Repair Importance Level: 1/3
Repair Difficulty Level: 1/3   
Comments  |  Add Comment

B1A09 LINCOLN Possible Causes

  • Blown Audio Fuse
  • Faulty Speaker
  • Speaker harness is open or shorted
  • Speaker circuit poor electrical connection
  • Faulty Audio amplifier
  • Faulty Subwoofer amplifier
  • Faulty Audio Control Module (ACM)

First diagnose B1A09 LINCOLN code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

B1A09 LINCOLN Tech Notes

B1A09:01 Speaker #9 General Electrical Failure
B1A09:11 Speaker #9 Circuit Short to Ground
B1A09:12 Speaker #9 Circuit Short to Battery
B1A09:13 Speaker #9 Circuit Open

Cost of diagnosing the B1A09 LINCOLN code

    Labor: 1.0

    The cost of diagnosing the B1A09 LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

B1A09 LINCOLN Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

B1a09 Lincoln Description

The Audio Control Module (ACM) directs audio signals to the audio amplifier and to the subwoofer amplifier in the form of an AC voltage. The amplifiers boost the audio signals and send them to the speakers. The ACM provides internal circuit protection for shorts to ground or shorts to voltage.
A short to ground or short to voltage in the circuitry to one of the speakers may cause multiple speakers to lose sound due to the built-in overload protection feature of the ACM. In this case, a speaker fault DTC sets, and this pinpoint test should be followed to isolate the damaged circuit.
To enable the amplifiers, the ACM sends voltage through individual enable/clip circuits. The circuits act as both an output (to enable the amplifier) and an input (to detect an overload condition). The voltage sent by the ACM passes through a variable resistor in each amplifier, then to ground. As the amplifier reaches maximum output, the resistance in the variable resistor decreases. This decreases the voltage drop, resulting in the ACM detecting a higher voltage on the enable/clip circuit. When the voltage reaches the clip threshold, the ACM clips the audio output signal to the amplifier (heard as distortion), in order to prevent damage to the amplifier and speakers.
The enable/clip status is based on the following voltages, as detected by the ACM:
- Less than 0.4 volts: amplifier disabled
- Between 3.8 and 6.7 volts (nominal): amplifier enabled
- Greater than 8.5 volts: amplifier clipped
An open in the enable/clip circuit causes the speakers powered by that particular amplifier to produce no sound because the enable signal does not reach the audio amplifier. A short to ground or short to voltage can cause severe distortion to be heard in the speakers.
OBDII Code B1a09 Lincoln - Speaker 9 General Electric Failure -

B1A09 LINCOLN More Information

Need more information on how to fix the B1A09 LINCOLN code?
Get Access to Factory Service Manuals

Need more help?

Get the B1a09 Lincoln code diagnosed by a professional: Find a repair shop in your area

Related Information

B1A09 LINCOLN Comments

Help us improve Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1a09 Lincoln code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧