The cost of diagnosing the B1941 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
|What are Code B1941 Possible Symptoms?
Air Bag Warning Light ON
|Code B1941 Description
The Selectable Force Limiter Squib Right (RH) Circuit consists of the Center Airbag Sensor Assembly and Front Seat Outer Belt Assembly Right (RH). This circuit instructs the Supplemental Restraint System (SRS) to deploy when the deployment conditions are met. The Diagnostic Trouble Code (DTC) is recorded when a malfunction is detected in the Selectable Force Limiter Squib Right Circuit.
B1941 Code - Open in Selectable Force Limiter Squib Right Circuit
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1941 code? Have you replaced any parts? Any information is appreciated. Thanks