| All About OBDII Engine Codes
AutoCodes - Generic - B1927

B1927 Code - Passenger Side Airbag Fault

- Code Popularity: 5,470 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By - Updated Jul 29, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1927 Possible Causes

  • Faulty Passenger Side Airbag
  • Passenger Side Airbag harness is open or shorted
  • Passenger Side Airbag circuit poor electrical connection

|How do I Fix the Code B1927?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Car have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1927?

Labor: 1.0

The cost of diagnosing the B1927 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1927 Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1927 Description

The Air Bag Control Module monitors the Passenger Side Airbag. The Air Bag Control Module sets the OBDII code when the Passenger Side Airbag is not to factory specifications.

OBDII Code B1927 - Passenger Side Airbag Fault -
B1927 Code - Passenger Side Airbag Fault

|Need More Information on the B1927 Code?

Need more information on how to fix the B1927 code? Get Access to Factory Service Manuals

|Information for Specific Makes

  • B1927 Lexus Short To Ground In Rear Pretensioner Squib LH Circuit
  • B1927 Scion Short To Ground In Rear Pretensioner Squib LH Circuit
  • B1927 Toyota Short To Ground In Rear Pretensioner Squib LH Circuit

|Need Help with the B1927 Code?

Get the B1927 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1927 comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1927 code? Have you replaced any parts?
Any information is appreciated. Thanks