AutoCodes.com | All About OBDII Engine Codes
AutoCodes - GMC - B1925 GMC

B1925 GMC Code - Driver Seat Cushion Heater Sensor

- Code Popularity: 1,922 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B1925 GMC?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Driver Seat Cushion Heater Replacement
  • Driver Seat Cushion Heater Replacement harness is open or shorted
  • Driver Seat Cushion Heater Replacement circuit poor electrical connection
  • Faulty Seat Heating Control Module
⚠ Does your GMC have Safety Recalls? → Check here

How to Fix the DTC B1925 GMC?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

B1925 02: Driver Seat Cushion Heater Sensor Circuit Short to Ground
B1925 05: Driver Seat Cushion Heater Sensor Circuit High Voltage/Open

Search for B1925 GMC Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B1925 GMC code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B1925 GMC Description

The heated seat temperature sensor that set this Diagnostic Trouble Code (DTC) is located in the seat cushion just under the seat cover with the seat heating element. The Seat Heating Control Module supplies a 5 V reference voltage through the temperature sensor signal circuit and a ground through the low reference circuit to the sensor. The module monitors the voltage of the sensor signal circuit to determine the temperature of the seat. The temperature sensor varies in resistance based on the temperature of the heating element causing the signal voltage to change. Once the seat reaches the set temperature, the module will then cycle the control circuit of the heating elements ON and OFF in order to maintain the desired seat temperature based on the feedback voltage from the sensor.

OBDII Code B1925 GMC - Driver Seat Cushion Heater Sensor - AutoCodes.com
B1925 GMC Code - Driver Seat Cushion Heater Sensor

Need More Information on the Code?

Need more information on how to fix the B1925 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1925 GMC code diagnosed by a professional: Find a repair shop in your area

Code B1925 GMC comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1925 GMC code? Have you replaced any parts?
Any information is appreciated. Thanks