AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B1918

B1918 Code - Air Bag Memory Clear Circuit Open

- Code Popularity: 3,703 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jul 27, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1918 Possible Causes

  • Faulty Air Bag Control Module
  • Air Bag Control Module harness is open or shorted
  • Air Bag Control Module circuit poor electrical connection

|How do I Fix the Code B1918?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Car have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1918?

Labor: 1.0

The cost of diagnosing the B1918 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1918 Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1918 Description

The Air Bag Control Module monitors the Air Bag Memory Clear Circuit. The Air Bag Control Module sets the OBDII code when the Air Bag Memory Clear Circuit is not to factory specifications.

OBDII Code B1918 - Air Bag Memory Clear Circuit Open - AutoCodes.com
B1918 Code - Air Bag Memory Clear Circuit Open

|Need More Information on the B1918 Code?

Need more information on how to fix the B1918 code? Get Access to Factory Service Manuals

|Need Help with the B1918 Code?

Get the B1918 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1918 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1918 code? Have you replaced any parts?
Any information is appreciated. Thanks