What are the Possible Causes of the DTC B1850 Toyota?
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
Faulty Rear Seat Side Airbag Assembly Right (RH) (Rear Side Squib Right Circuit)
Rear Seat Side Airbag Assembly Right Left harness is open or shorted
Rear Seat Side Airbag Assembly Right Left circuit poor electrical connection
Faulty Center Airbag Sensor Assembly
⚠ Does your Toyota have Safety Recalls? → Check here
How to Fix the DTC B1850 Toyota?
Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
Search for B1850 Toyota Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the B1850 Toyota code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Air Bag Warning Light ON
Code B1850 Toyota Description
The Rear Side Squib Right (RH) Circuit consists of the Center Airbag Sensor Assembly and the Rear Seat Side Airbag Assembly Right (RH). This circuit instructs the Supplemental Restraint System (SRS) to deploy when deployment conditions are met. The Diagnostic Trouble Code (DTC) is stored when a malfunction is detected in the Rear Side Squib Right Circuit.
B1850 Toyota Code - Short In Rear Side Squib Right Circuit
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed,
it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1850 Toyota code? Have you replaced any parts? Any information is appreciated. Thanks