AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - B1693

B1693 Code - Door Side Airbag Sensor Right Initialization Incomplete

- Code Popularity: 13,406 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B1693?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Side Airbag Sensor Right (RH)
  • Side Airbag Sensor Right harness is open or shorted
  • Side Airbag Sensor Right circuit poor electrical connection
  • Faulty Rear Airbag Sensor Right (RH)
  • Faulty Center Airbag Sensor Assembly
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC B1693?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B1693 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B1693 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B1693 Description

The Side Collision Sensor Right (RH) circuit is composed of the Center Airbag Sensor Assembly, Side Airbag Sensor Right, and Rear Airbag Sensor Right. The Side Airbag Sensor Right and Rear Airbag Sensor Right detect impacts to the vehicle and send signals to the Center Airbag Sensor Assembly to determine if the airbag should be deployed. The Diagnostic Trouble Code (DTC) is stored when a malfunction is detected for the Side Collision Right circuit (to determine deployment of the Front Seat Side Airbag Assembly Right and Curtain Shield Airbag Assembly Right).

OBDII Code B1693 - Door Side Airbag Sensor Right Initialization Incomplete - AutoCodes.com
B1693 Code - Door Side Airbag Sensor Right Initialization Incomplete

Need More Information on the Code?

Need more information on how to fix the B1693 code? Get Access to Factory Service Manuals

Information for Specific Makes

Need Help with the Code?

Get the B1693 code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B1693 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1693 code? Have you replaced any parts?
Any information is appreciated. Thanks