AutoCodes
 
OBDII Code List
 
B1650 SCION

B1650 SCION - Occupant Classification System Fault

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

B1650 SCION Possible Causes

  • Faulty Occupant Classification System
  • Faulty Airbags Sensor Assembly Center
  • Faulty Right Front Seat Wire

First diagnose B1650 SCION code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the B1650 SCION code

    Labor: 1.0

    The cost of diagnosing the B1650 SCION code is 1.0 hour of labor. The auto repair labor rates vary widely across the country, and even within the same city. Most auto repairs shops charge between $75 and $150 per hour.

B1650 SCION Possible Symptoms

  • Airbag Warning Light ON

B1650 Scion Description

The Occupant Classification System circuit consists of the Airbag Sensor Assembly Center and the Occupant Classification System. If the Airbags Sensor Assembly Center receives signals from the Occupant Classification ECU, it determines whether or not the Front Passenger Airbag Assembly and the Front Seat Airbag Assembly sight should be operated. The B1650 code is recorded when a malfunction is detected in the Occupant Classification System.
OBDII Code B1650 Scion - Occupant Classification System Fault - AutoCodes.com

B1650 SCION More Information

Need more information on how to fix the B1650 SCION code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1650 Scion code diagnosed by a professional: Find a repair shop in your area

Related Information

B1650 SCION Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1650 Scion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧