AutoCodes - OBDII Code List - B14FE FORD

B14FE FORD - Low Side Driver 6

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Comments  |  Add Comment

B14FE FORD Possible Causes

  • Faulty Upfitter Interface Module
  • Upfitter Interface Module harness is open or shorted
  • Upfitter Interface Module circuit poor electrical connection

How do I fix code B14FE FORD

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

B14FE:11 Low Side Driver 6 Short To Ground
B14FE:12 Low Side Driver 6 Short To battery
B14FE:13 Low Side Driver 6 Open Circuit

Cost of diagnosing the B14FE FORD code

Labor: 1.0

The cost of diagnosing the B14FE FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

B14fe Ford Description

The Upfitter Interface Module utilizes a Field Effect Transistor (FET) protective circuit strategy to protect the low and high side driver output circuits. Output loads (current levels) are monitored for excessive current (which is typically caused by a short circuit to ground) and are shut down (turns off the voltage or ground provided by the module) when a fault is detected.
A short to battery voltage occurring on either a low or high side driver output circuit may also result in a temporarily loss of operation in the output circuit (no voltage or ground will be applied to the output circuit) to protect the module against a potential over temperature condition.
A Field Effect Transistor (FET) is a type of transistor that the module uses to control and monitor current flow on module output circuits. The Field Effect Transistor (FET) protection strategy prevents damage from occurring to the module.
Whenever a FET is turned off because of a fault condition a Diagnostic Trouble Code (DTC) is set in the module which corresponds to the specific fault observed. The module resets the Field Effect Transistor (FET) protection and allows the circuit to function when the fault is corrected or the ignition is cycled off and then back on. The ignition should always be cycled from off to on after a fault is corrected to ensure that FET protection is reset.
OBDII Code B14fe Ford - Low Side Driver 6 - AutoCodes.com

B14FE FORD More Information

Need more information on how to fix the B14FE FORD code?
Get Access to Factory Service Manuals

Need more help?

Get the B14fe Ford code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B14fe Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧