B14F2 FORD Code - High Side Driver 3
|B14F2 FORD code possible causes
- Faulty Upfitter Interface Module
- Upfitter Interface Module harness is open or shorted
- Upfitter Interface Module circuit poor electrical connection
|How do I fix the B14F2 FORD code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B14F2 FORD code tech notesB14F2:11 High Side Driver 3 Short To Ground
B14F2:12 High Side Driver 3 Short To battery
B14F2:13 High Side Driver 3 Open Circuit
|Cost of diagnosing the B14F2 FORD code
Labor: 1.0The cost of diagnosing the B14F2 FORD code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B14F2 FORD code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|B14F2 FORD code descriptionThe Upfitter Interface Module utilizes a Field Effect Transistor (FET) protective circuit strategy to protect the low and high side driver output circuits. Output loads (current levels) are monitored for excessive current (which is typically caused by a short circuit to ground) and are shut down (turns off the voltage or ground provided by the module) when a fault is detected.
A short to battery voltage occurring on either a low or high side driver output circuit may also result in a temporarily loss of operation in the output circuit (no voltage or ground will be applied to the output circuit) to protect the module against a potential over temperature condition.
A Field Effect Transistor (FET) is a type of transistor that the module uses to control and monitor current flow on module output circuits. The Field Effect Transistor (FET) protection strategy prevents damage from occurring to the module.
Whenever a FET is turned off because of a fault condition a Diagnostic Trouble Code (DTC) is set in the module which corresponds to the specific fault observed. The module resets the Field Effect Transistor (FET) protection and allows the circuit to function when the fault is corrected or the ignition is cycled off and then back on. The ignition should always be cycled from off to on after a fault is corrected to ensure that FET protection is reset.
|Need more information with the B14F2 FORD code?Need more information on how to fix the B14F2 FORD code? Get Access to Factory Service Manuals
|Need help with a B14F2 FORD code?Get the B14f2 Ford code diagnosed by a professional: Find a repair shop in your area
|B14F2 FORD code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B14f2 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks