Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
B14B9-2B CHANNEL 9 AUDIO SPEAKER OUTPUT WIRES SHORTED TOGETHER
B14B9-11 CHANNEL 9 AUDIO SPEAKER OUTPUT CIRCUIT SHORT TO GROUND
B14B9-12 CHANNEL 9 AUDIO SPEAKER OUTPUT CIRCUIT SHORT TO BATTERY
B14B9-13 CHANNEL 9 AUDIO SPEAKER OUTPUT CIRCUIT OPEN
B14B9-92 CHANNEL 9 AUDIO SPEAKER OUTPUT PERFORMANCE OR INCORRECT OPERATION
To diagnose the B14B9 Chrysler code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The amplifier receives fused battery current from a fuse in the Power Distribution Center (PDC) at all times. The internal circuitry of the amplifier switches the amplifier on based upon a CAN-I bus message that is received from the Radio Receiver Module (RRM) whenever the RRM is turned on. The amplifier receives the sound signal inputs from the left and right rear outputs of the RRM, and then sends the amplified speaker outputs for each of those channels to the speakers.
The amplifier receives information from the Body Control Module (BCM) and RRM, that communicates the correct channel setting for optimum speaker sound and output.
There are two amplifiers available, an 8 channel, rated at 322 watts (7 channels are used) and a 12 channel (11 channels are used), rated at 506 watts.
Need more information on how to fix the B14B9 Chrysler code? Get Access to Factory Service Manuals
Get the B14B9 Chrysler code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B14B9 Chrysler code? Have you replaced any parts?
Any information is appreciated. Thanks