AutoCodes - OBDII Code List - B1480 HYUNDAI

B1480 HYUNDAI - Passenger Curtain Airbag Circuit Short To Battery

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Comments  |  Add Comment

B1480 HYUNDAI Possible Causes

  • Faulty Passenger Curtain Airbag (CAB) Squib
  • Passenger Curtain Airbag (CAB) Squib harness is open or shorted
  • Passenger Curtain Airbag (CAB) Squib circuit poor electrical connection
  • Faulty Supplemental Restraints System Control Module (SRSCM)

How do I fix code B1480 HYUNDAI

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1480 HYUNDAI code

Labor: 1.0

The cost of diagnosing the B1480 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B1480 Hyundai Description

The Curtain Airbag (CAB) Squib circuit consists of the Supplemental Restraints System Control Module (SRSCM) and two Curtain Airbag. It causes the Supplemental Restraints System (SRS) to deploy when the SRS deployment conditions are satisfied. The OBDII Diagnostic Trouble Code (DTC) is recorded when short to battery is detected in the CAB squib circuit.
OBDII Code B1480 Hyundai - Passenger Curtain Airbag Circuit Short To Battery - AutoCodes.com

B1480 HYUNDAI More Information

Need more information on how to fix the B1480 HYUNDAI code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1480 Hyundai code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1480 Hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧