AutoCodes - Kia - B1478 KIA

B1478 KIA Code - Passenger Curtain Airbag Resistance Too Low

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|B1478 KIA code possible causes

  • Faulty Passenger Curtain Airbag (CAB) Squib
  • Passenger Curtain Airbag (CAB) Squib harness is open or shorted
  • Passenger Curtain Airbag (CAB) Squib circuit poor electrical connection
  • Faulty Supplemental Restraints System Control Module (SRSCM)

|How do I fix the B1478 KIA code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the B1478 KIA code

Labor: 1.0

The cost of diagnosing the B1478 KIA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B1478 KIA code possible symptoms?

  • Air Bag Warning Light ON

|B1478 KIA code description

The Curtain Airbag (CAB) Squib circuit consists of the Supplemental Restraints System Control Module (SRSCM) and two Curtain Airbag. It causes the Supplemental Restraints System (SRS) to deploy when the SRS deployment conditions are satisfied. The OBDII Diagnostic Trouble Code (DTC) is recorded when the CAB resistance too high or low is detected in the CAB squib circuit.
OBDII Code B1478 Kia - Passenger Curtain Airbag Resistance Too Low - AutoCodes.com

|Need more information with the B1478 KIA code?

Need more information on how to fix the B1478 KIA code? Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Need help with a B1478 KIA code?

Get the B1478 Kia code diagnosed by a professional: Find a repair shop in your area

|B1478 KIA code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1478 Kia code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?