AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Hyundai - B1476 HYUNDAI

B1476 HYUNDAI Code - Driver Curtain Airbag Circuit Short To Battery

- Code Popularity: 688 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Apr 12, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|B1476 HYUNDAI code possible causes

  • Faulty Driver Curtain Airbag (CAB) Squib
  • Driver Curtain Airbag (CAB) Squib harness is open or shorted
  • Driver Curtain Airbag (CAB) Squib circuit poor electrical connection
  • Faulty Supplemental Restraints System Control Module (SRSCM)

|How do I fix code B1476 HYUNDAI code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|Cost of diagnosing B1476 HYUNDAI code

Labor: 1.0

The cost of diagnosing the B1476 HYUNDAI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are B1476 HYUNDAI code possible symptoms?

  • Air Bag Warning Light ON

|B1476 HYUNDAI code description

The Curtain Airbag (CAB) Squib circuit consists of the Supplemental Restraints System Control Module (SRSCM) and two Curtain Airbag. It causes the Supplemental Restraints System (SRS) to deploy when the SRS deployment conditions are satisfied. The OBDII Diagnostic Trouble Code (DTC) is recorded when short to battery is detected in the CAB squib circuit.

OBDII Code b1476 hyundai - Driver Curtain Airbag Circuit Short To Battery - AutoCodes.com
B1476 HYUNDAI Code - Driver Curtain Airbag Circuit Short To Battery

|Need more information with the B1476 HYUNDAI code?

Need more information on how to fix the B1476 HYUNDAI code? Get Access to Factory Service Manuals

|Need help with a B1476 HYUNDAI code?

Get the b1476 hyundai code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|B1476 HYUNDAI code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the b1476 hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks