AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Dodge - B146A Dodge

B146A Dodge Code - Channel 3 Audio Speaker Output Circuit Performance

- Code Popularity: 616 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B146A Dodge?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Audio Amplifier
  • Audio Amplifier harness is open or shorted
  • Audio Amplifier circuit poor electrical connection
⚠ Does your Dodge have Safety Recalls? → Check here

How to Fix the DTC B146A Dodge?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B146A Dodge Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B146A Dodge code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B146A Dodge Description

The standard equipment speaker system includes four full-range speakers. The two front speakers are mounted behind a removable bezel located on each outboard end of the lower instrument panel. With the premium speaker system, the standard front speakers are replace with an enclosure assembly that includes a 4 inch speaker and a 1 inch tweeter. The four rear speakers are mounted behind a grille located on each outboard end of the sport bar, above the rear seating area of the vehicle. This Diagnostic Trouble Code (DTC) sets if a Direct Current (DC) offset occurs on the output channel, the amplifier shall set a DTC after a maturity rate of four to six seconds.

OBDII Code B146A Dodge - Channel 3 Audio Speaker Output Circuit Performance - AutoCodes.com
B146A Dodge Code - Channel 3 Audio Speaker Output Circuit Performance

Need More Information on the Code?

Need more information on how to fix the B146A Dodge code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B146A Dodge code diagnosed by a professional: Find a repair shop in your area

Code B146A Dodge comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B146A Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks