AutoCodes - Kia - B1449 KIA

B1449 KIA Code - Passenger Occupant Classification System Communication Error

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|B1449 KIA code possible causes

  • Faulty Passenger Occupant Classification Sensor
  • Passenger Occupant Classification Sensor harness is open or shorted
  • Passenger Occupant Classification Sensor circuit poor electrical connection
  • Faulty Occupant Classification (OC) Module
  • Faulty Supplemental Restraints System Control Module (SRSCM)

|How do I fix the B1449 KIA code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the B1449 KIA code

Labor: 1.0

The cost of diagnosing the B1449 KIA code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are B1449 KIA code possible symptoms?

  • Air Bag Warning Light ON

|B1449 KIA code description

The Passenger Occupant Classification System consists of the Supplemental Restraints System Control Module (SRSCM) and the Occupant Classification (OC) Module. The Diagnostic Trouble Code (DTC) is recorded when a defect or communication error of the OC module is detected in the OC module circuit.
OBDII Code B1449 Kia - Passenger Occupant Classification System Communication Error - AutoCodes.com

|Need more information with the B1449 KIA code?

Need more information on how to fix the B1449 KIA code? Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Need help with a B1449 KIA code?

Get the B1449 Kia code diagnosed by a professional: Find a repair shop in your area

|B1449 KIA code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1449 Kia code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?