B1418 LINCOLN Code - Driver Side Restraints Sensor 1
|B1418 LINCOLN code possible causes
- Faulty Driver Side Restraints Sensor 1
- Driver Side Restraints Sensor 1 harness is open or shorted
- Driver Side Restraints Sensor 1 circuit poor electrical connection
- Faulty Restraint Control Module (RCM)
|How do I fix the B1418 LINCOLN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B1418 LINCOLN code tech notesB1418:11 Passenger Side Restraints Sensor 1 Circuit Short to Ground
B1418:93 Passenger Side Restraints Sensor 1 No Operation
|Cost of diagnosing the B1418 LINCOLN code
Labor: 1.0The cost of diagnosing the B1418 LINCOLN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1418 LINCOLN code possible symptoms?
- Air Bag Warning Light ON
|B1418 LINCOLN code descriptionThe Restraint Control Module (RCM) monitors the passenger front door and LH C-pillar side impact sensors and circuits for the following faults: Open circuit, Short to voltage, Short to ground, Faulted passenger front door side impact sensor, Faulted LH C-pillar side impact sensor. If a fault is detected, the RCM stores DTC B1418 in memory and sends a message to the Instrument Panel Cluster (IPC) to illuminate the airbag warning indicator. The RCM communicates with each impact sensor. If the RCM is unable to communicate with the sensor, a Diagnostic Trouble Code (DTC) is stored in memory. A Continuous Memory Diagnostic Trouble Code (CMDTC) no operation can be set by a short to voltage on the return circuit of the impact sensor.
|Need more information with the B1418 LINCOLN code?Need more information on how to fix the B1418 LINCOLN code?
Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
|Need help with a B1418 LINCOLN code?Get the B1418 Lincoln code diagnosed by a professional: Find a repair shop in your area
|B1418 LINCOLN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1418 Lincoln code? Have you replaced any parts?
Any information is appreciated. Thanks