AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mercury - B1415 Mercury

B1415 Mercury Code - Driver Side Restraints Sensor 2

- Code Popularity: 598 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B1415 Mercury?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Driver Side Restraints Sensor 2
  • Driver Side Restraints Sensor 2 harness is open or shorted
  • Driver Side Restraints Sensor 2 circuit poor electrical connection
  • Faulty Restraint Control Module (RCM)
⚠ Does your Mercury have Safety Recalls? → Check here

How to Fix the DTC B1415 Mercury?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

B1415:11 Driver Side Restraints Sensor 2 Circuit Short to Ground
B1415:93 Driver Side Restraints Sensor 2 No Operation

Search for B1415 Mercury Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B1415 Mercury code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Air Bag Warning Light ON

Code B1415 Mercury Description

The Restraint Control Module (RCM) monitors the passenger front door and LH C-pillar side impact sensors and circuits for the following faults: Open circuit, Short to voltage, Short to ground, Faulted passenger front door side impact sensor, Faulted LH C-pillar side impact sensor. If a fault is detected, the RCM stores DTC B1415 in memory and sends a message to the Instrument Panel Cluster (IPC) to illuminate the airbag warning indicator. The RCM communicates with each impact sensor. If the RCM is unable to communicate with the sensor, a Diagnostic Trouble Code (DTC) is stored in memory. A Continuous Memory Diagnostic Trouble Code (CMDTC) no operation can be set by a short to voltage on the return circuit of the impact sensor.

OBDII Code B1415 Mercury - Driver Side Restraints Sensor 2 - AutoCodes.com
B1415 Mercury Code - Driver Side Restraints Sensor 2

Need More Information on the Code?

Need more information on how to fix the B1415 Mercury code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1415 Mercury code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Code B1415 Mercury comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1415 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks