B1379 HYUNDAI Code - Front-Driver Side Airbag Resistance Too Low
|B1379 HYUNDAI code possible causes
- Faulty Front-Driver Side Airbag
- Front-Driver Side Airbag harness is open or shorted
- Front-Driver Side Airbag circuit poor electrical connection
- Faulty Supplemental Restraint System Control Module (SRSCM)
|How do I fix the B1379 HYUNDAI code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the B1379 HYUNDAI code
Labor: 1.0The cost of diagnosing the B1379 HYUNDAI code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B1379 HYUNDAI code possible symptoms?
- Air Bag Warning Light ON
|B1379 HYUNDAI code descriptionThe Side Airbag located in driver and passenger seat protects passenger head and shoulder. The Side Airbag consists of airbag and inflator. The airbag reduces the impact of a collision by filling up gas. Inflator keeps gas and uses it to deploy airbag on collision. The Supplemental Restraint System Control Module (SRSCM) sets the Diagnostic Trouble Code (DTC) if it detects that the resistance of Side Airbag is not to factory specifications.
|Need more information with the B1379 HYUNDAI code?Need more information on how to fix the B1379 HYUNDAI code? Get Access to Factory Service Manuals
Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service
- Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
- Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
- Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
- Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
|Need help with a B1379 HYUNDAI code?Get the B1379 Hyundai code diagnosed by a professional: Find a repair shop in your area
|B1379 HYUNDAI code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1379 Hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks