AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Cadillac - B1372 Cadillac

B1372 Cadillac Code - Device Ignition On and Start Circuit Low

- Code Popularity: 738 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC B1372 Cadillac?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Ignition Switch
  • Ignition Switch harness is open or shorted
  • Ignition Switch circuit poor electrical connection
  • Faulty Body Control Module (BCM)
⚠ Does your Cadillac have Safety Recalls? → Check here

How to Fix the DTC B1372 Cadillac?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for B1372 Cadillac Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the B1372 Cadillac code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code B1372 Cadillac Description

The vehicle Power Mode Master (PMM) is the Body Control Module (BCM). The ignition switch is a low current switch with multiple discrete ignition switch signals to the PMM for determination of the power mode. The PMM receives the ignition switch signals, and additionally a reference voltage signal from the BCM, through the ignition switch, and back to the BCM. There are redundancies within the PMM system that can allow operation of certain subsystems when there are faults in the ignition switch circuits. Other information such as serial data input from other modules and DTCs is also used to determine what power mode signals and information is transmitted by the PMM. The BCM logic uses all this information to identify the operator's desired power mode and activate specific discrete signals, and serial data messages for the operation of different subsystems as necessary. Other modules which have switched voltage inputs may operate in a default mode if the PMM serial data message does not match what the individual module can detect from its own connections.
The PMM will activate relays and other direct outputs of the PMM as needed according to the calculated power mode. Some relays controlled by the BCM are switched ignition voltage outputs that are pass through circuits within the BCM directly from the ignition switch. If these circuits short to ground, the B+ circuit fuse to the ignition switch will open.

OBDII Code B1372 Cadillac - Device Ignition On and Start Circuit Low - AutoCodes.com
B1372 Cadillac Code - Device Ignition On and Start Circuit Low

Need More Information on the Code?

Need more information on how to fix the B1372 Cadillac code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the B1372 Cadillac code diagnosed by a professional: Find a repair shop in your area

Code B1372 Cadillac comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1372 Cadillac code? Have you replaced any parts?
Any information is appreciated. Thanks