AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Hyundai - B1347 Hyundai

B1347 Hyundai Code - Driver-Side Air Bag Module First Stage Resistance Low

- Code Popularity: 11,217 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Mar 15, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1347 Hyundai Possible Causes

  • Faulty Driver-Side Air Bag Module
  • Driver-Side Air Bag Module harness is open or shorted
  • Driver-Side Air Bag Module circuit poor electrical connection
  • Faulty Clock Spring
  • Faulty Supplemental Restraint System Control Module (SRSCM)

|How do I Fix the Code B1347 Hyundai?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Hyundai have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1347 Hyundai?

Labor: 1.0

The cost of diagnosing the B1347 Hyundai code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1347 Hyundai Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1347 Hyundai Description

The Driver Air Bag Module located at the center of steering wheel protects the driver by reducing the impact of a collision. The Driver Air Bag Module consists of the air bag, pat cover and two inflators. Air Bag reduces the impact of a collision by filling up gas. In the event of a collision, the pat cover splits and through this crack, air bag emerges and deploys. The Inflator generates gas that expands air bag. Clock spring is located between the steering wheel and column and connects the Supplemental Restraint System Control Module (SRSCM) to Driver Air Bag Module.

OBDII Code B1347 Hyundai - Driver-Side Air Bag Module First Stage Resistance Low - AutoCodes.com
B1347 Hyundai Code - Driver-Side Air Bag Module First Stage Resistance Low

|Need More Information on the B1347 Hyundai Code?

Need more information on how to fix the B1347 Hyundai code? Get Access to Factory Service Manuals

|Need Help with the B1347 Hyundai Code?

Get the B1347 Hyundai code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1347 Hyundai comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1347 Hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks