| All About OBDII Engine Codes
AutoCodes - Hyundai - B1327 Hyundai

B1327 Hyundai Code - Driver-Side Front Impact Sensor Short To Battery

- Code Popularity: 3,071 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By - Updated Mar 14, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|Code B1327 Hyundai Possible Causes

  • Faulty Driver-Side Front Impact Sensor (FIS)
  • Driver-Side Front Impact Sensor harness is open or shorted
  • Driver-Side Front Impact Sensor circuit poor electrical connection
  • Faulty Supplemental Restraint System Control Module (SRSCM)

|How do I Fix the Code B1327 Hyundai?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Hyundai have Safety Recalls? → Check here

|What is the Cost to Diagnose the Code B1327 Hyundai?

Labor: 1.0

The cost of diagnosing the B1327 Hyundai code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|What are Code B1327 Hyundai Possible Symptoms?

  • Air Bag Warning Light ON

|Code B1327 Hyundai Description

The detecting system for the front crash consists of the Supplemental Restraint System Control Module (SRSCM) and two Front Impact Sensors (FIS). The Front Impact Sensors are located at both sides of the front of the engine room. When FIS delivers collision signal to SRSCM, SRSCM checks if safing sensor located in SRSCM detects collusion, and if both FIS and the safing sensor detects collision simultaneously, SRSCM operates front airbag. The SRSCM sets the Diagnostic Trouble Code (DTC) (s) if it detects that any FIS is defective or there is a communication error between any FIS and the SRSCM.

OBDII Code B1327 Hyundai - Driver-Side Front Impact Sensor Short To Battery -
B1327 Hyundai Code - Driver-Side Front Impact Sensor Short To Battery

|Need More Information on the B1327 Hyundai Code?

Need more information on how to fix the B1327 Hyundai code? Get Access to Factory Service Manuals

|Need Help with the B1327 Hyundai Code?

Get the B1327 Hyundai code diagnosed by a professional: Find a repair shop in your area

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

|Code B1327 Hyundai comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B1327 Hyundai code? Have you replaced any parts?
Any information is appreciated. Thanks