B12CA FORD - Start/Stop Eco-Start Status Indicator Circuit Short
B12CA FORD Possible Causes
- Faulty Start/Stop Button
- Start/Stop Button harness is open or shorted
- Start/Stop Button circuit poor electrical connection
How do I fix code B12CA FORD?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the B12CA FORD code
Labor: 1.0The cost of diagnosing the B12CA FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
B12CA FORD DescriptionThe stop-start disable button is a momentary contact switch. It is normally open, Controlled Area Network (CAN) signal low. Closed (button being pushed) is CAN signal high. The Front Controls Interface Module reads the switch status and sends it over CAN to the Powertrain Control Module (PCM). If the button is stuck open, there are no low to high transitions. Since the PCM does not recognize a button push, stop-start will not be disabled if requested by the customer. If the button is stuck closed, there are no low to high transitions. Since the PCM does not recognize a button push, stop-start will not be disabled if requested by the customer.
More InformationNeed more information on how to fix the B12CA FORD code?
Get Access to Factory Service Manuals
Need more help?Get the B12ca Ford code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B12ca Ford code? Have you replaced any parts?
Any information is appreciated. Thanks