AutoCodes - OBDII Code List - B1213 LINCOLN

B1213 LINCOLN - Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Comments  |  Add Comment

B1213 LINCOLN Possible Causes

  • Faulty Passenger Seatbelt Buckle Pretensioner
  • Passenger Seatbelt Buckle Pretensioner harness is open or shorted
  • Passenger Seatbelt Buckle Pretensioner circuit poor electrical connection
  • Faulty Restraints Control Module (RCM)

How do I fix code B1213 LINCOLN

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

B1213:11 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Short to Ground
B1213:12 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Short to Battery
B1213:13 Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Open
B1213:1A Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit Resistance Below Threshold

Cost of diagnosing the B1213 LINCOLN code

Labor: 1.0

The cost of diagnosing the B1213 LINCOLN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B1213 Lincoln Description

The Restraints Control Module (RCM) analyzes the deployment loop resistance to determine if a fault exists. The value displayed in the PID is the deployment loop resistance measured by the RCM. If the value displayed is lower or higher than the desired range, the RCM can set a Diagnostic Trouble Code (DTC). As the deployment loop resistance drifts farther outside the desired range, the chance for a DTC increases. Small variations in resistance can occur due to the effect of road vibrations on terminal fit. Crimps and terminals can be affected by stress and harness movement and can cause an increase in resistance due to wire strain. These variables can result in an intermittent fault. For this reason, the test requires the PID value to be within the desired range before the fault is considered repaired, regardless if the module is reporting an on-demand DTC at the time of diagnosis. Following this direction helps make sure that minor changes in resistance do not create a repeat concern.
OBDII Code B1213 Lincoln - Passenger Seatbelt Buckle Pretensioner Deployment Control Circuit - AutoCodes.com

B1213 LINCOLN More Information

Need more information on how to fix the B1213 LINCOLN code?
Get Access to Factory Service Manuals

Need more help?

Get the B1213 Lincoln code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1213 Lincoln code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧