B11E7 MERCURY - Air Distribution Damper Position Sensor Circuit
B11E7 MERCURY Possible Causes
- Faulty Air Distribution Damper Position Sensor
- Air Distribution Damper Position Sensor harness is open or shorted
- Air Distribution Damper Position Sensor circuit poor electrical connection
- Faulty Heating, Ventilation, and Air Conditioning (HVAC) Module
First diagnose B11E7 MERCURY code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
B11E7 MERCURY Tech NotesB11E7:11 - Air Distribution Damper Position Sensor: Circuit Short to Ground
B11E7:15 - Air Distribution Damper Position Sensor: Circuit Short to Battery or Open
Cost of diagnosing the B11E7 MERCURY code
Labor: 1.0The cost of diagnosing the B11E7 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
B11E7 MERCURY Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
B11e7 Mercury DescriptionTo rotate the defrost/panel/floor mode door actuator, the Heating, Ventilation, and Air Conditioning (HVAC) Module supplies voltage and ground to the defrost/panel/floor mode door actuator motor through the actuator motor circuits. To reverse the defrost/panel/floor mode door actuator rotation, the HVAC module reverses the voltage and ground circuits.
The defrost/panel/floor mode door actuator feedback resistor is supplied a 5-volt reference voltage and ground from the HVAC module. The HVAC module measures the resistance on the defrost/panel/floor mode door actuator feedback circuit to determine the defrost/panel/floor mode door actuator position by the position of the actuator feedback resistor wiper arm.
During an actuator calibration cycle, the HVAC module drives the defrost/panel/floor mode door until the door reaches both internal stops in the HVAC case. If the defrost/panel/floor mode door is temporarily obstructed or binding during a calibration cycle, the HVAC module may interpret this as the actual end of travel for the door. When this condition occurs and the HVAC module commands the actuator to its end of travel, the airflow may not be from the expected outlets.
B11E7 MERCURY More InformationNeed more information on how to fix the B11E7 MERCURY code?
Get Access to Factory Service Manuals
Need more help?Get the B11e7 Mercury code diagnosed by a professional: Find a repair shop in your area
B11E7 MERCURY CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B11e7 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks