B11E6 Code - Right HVAC Damper Position Sensor Circuit
|B11E6 code possible causes
- Faulty Right HVAC Damper Position Sensor
- Right HVAC Damper Position Sensor harness is open or shorted
- Right HVAC Damper Position Sensor circuit poor electrical connection
- Faulty Heating, Ventilation, and Air Conditioning (HVAC) Module
|How do I fix the B11E6 code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|B11E6 code tech notesB11E6:11 - Right HVAC Damper Position Sensor: Circuit Short to Ground
B11E6:15 - Right HVAC Damper Position Sensor: Circuit Short to Battery or Open
|Cost of diagnosing the B11E6 code
Labor: 1.0The cost of diagnosing the B11E6 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|What are B11E6 code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
|B11E6 code descriptionTo rotate the temperature blend door actuator, the Heating, Ventilation, and Air Conditioning (HVAC) Module supplies voltage and ground to the temperature blend door actuator through the door actuator motor circuits. To reverse the temperature blend door actuator rotation, the HVAC module reverses the voltage and ground circuits.
The temperature blend door actuator feedback resistors are supplied a ground from the HVAC module by the temperature blend door actuator return circuits and a 5-volt reference voltage on the temperature blend door actuator reference circuits. The HVAC module reads the voltage on the temperature blend door actuator feedback circuits to determine the temperature blend door actuator position by the position of the actuator feedback resistor wiper arm.
During an actuator calibration cycle, the HVAC module drives the temperature blend door until the door reaches both internal stops in the HVAC case. If the temperature blend door is temporarily obstructed or binding during a calibration cycle, the HVAC module may interpret this as the actual end of travel for the door. When this condition occurs and the HVAC module commands the actuator to its end of travel, the airflow may not be the expected temperature.
|Need more information with the B11E6 code?Need more information on how to fix the B11E6 code? Get Access to Factory Service Manuals
|B11E6 code information for specific makes
|Need help with a B11E6 code?Get the B11e6 code diagnosed by a professional: Find a repair shop in your area
|B11E6 code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the B11e6 code? Have you replaced any parts?
Any information is appreciated. Thanks