AutoCodes - OBDII Code List - B1182 NISSAN

B1182 NISSAN - Left Front Seat Belt Buckle Pre-Tensioner Open

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

B1182 NISSAN Possible Causes

  • Faulty Left Front Seat Belt Buckle Pre-Tensioner
  • Left Front Seat Belt Buckle Pre-Tensioner harness is open or shorted
  • Left Front Seat Belt Buckle Pre-Tensioner circuit poor electrical connection
  • Faulty Air Bag Sensor Unit (Air Bag Control Module)

How do I fix code B1182 NISSAN?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the B1182 NISSAN code

Labor: 1.0

The cost of diagnosing the B1182 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Air Bag Warning Light ON

B1182 NISSAN Description

The Air Bag Sensor Unit (Air Bag Control Module) monitors the Left Front Seat Belt Buckle Pre-Tensioner. The Air Bag Sensor Unit sets the OBDII code when the circuit for the front Left Front Seat Belt Buckle Pre-Tensioner is open.
OBDII Code B1182 Nissan - Left Front Seat Belt Buckle Pre-Tensioner Open - AutoCodes.com

More Information

Need more information on how to fix the B1182 NISSAN code?
Get Access to Factory Service Manuals

Precautions for SRS “AIR BAG” and “SEAT BELT PRE-TENSIONER” Service

  • Never probe the electrical connectors on air bag, side air curtain modules or seat belts.
  • Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors.
  • Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
  • Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed.
Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

Need more help?

Get the B1182 Nissan code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the B1182 Nissan code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧